San Diego Toilet Repair Pros
Home › Services › Running toilet repair

Running Toilet Repair in San Diego

A running toilet wastes water around the clock and is one of the cheapest fixtures to repair. We find the failed part, replace it, and give you a price first.

Typical range: $95 to $250 · Free estimate first
Call (888) 784-0722Free estimates · Open 24/7
Open toilet tank showing a flapper, fill valve and overflow tube

What "running" usually means

If you hear the toilet refill when nobody flushed, or you hear a faint hiss or trickle, water is leaking from the tank into the bowl or the tank is overfilling into the overflow tube. Either way, you are paying for water that goes straight down the drain. The EPA notes that a leaking toilet can waste hundreds of gallons a day in the worst cases.

Handle and chainOverflow tubeFill valve and floatFlapper seals here
Tank anatomy: a worn flapper or a mis-set fill valve causes most running toilets.

The four parts that fail

  • Flapper. The rubber seal at the bottom of the tank. Over the years it warps, hardens or collects mineral scale and stops sealing. This is the most common cause.
  • Fill valve. Controls how much water enters the tank. Worn seals or a clogged screen cause slow filling, hissing, or constant running.
  • Float. If it is set too high, water spills into the overflow tube continuously.
  • Chain. Too tight and it holds the flapper open, too loose and it jams under the flapper. This is a two-minute fix if that is all it is.

Try this before you call

Put a few drops of food coloring in the tank and do not flush. If color shows up in the bowl within 15 minutes, the flapper is leaking. Our guide on running toilets: DIY versus plumber walks through the test and what you can safely change yourself.

What we do

We shut off the water, inspect every tank component, and replace what is worn, not just what is obvious. Replacing only a flapper while a fill valve is failing means a second callback. We reset the water level to the manufacturer's line, adjust the chain, test flush several times, and confirm the tank holds level with the water off overnight if needed.

Why it happens more here

San Diego's very hard water leaves scale on the flapper seat and fill valve screen, which prevents a clean seal. We also see rubber parts hardening early in some homes, and many plumbers point to disinfectant chemistry as a factor. Frequent use in Pacific Beach short-term rentals wears these parts quickly too. Details in San Diego hard water and toilets.

Typical San Diego pricing

RepairTypical range
Flapper and chain replacement$95 to $180
Fill valve replacement$110 to $220
Full tank rebuild (flapper, fill valve, flush valve seal)$150 to $250

Free written estimate first. If the tank or bowl is cracked, we will say so, and a replacement may be the smarter spend. See toilet replacement.

Common questions

How much does it cost to fix a running toilet in San Diego?
Most run $95 to $250 depending on whether it is a flapper, a fill valve, or a full rebuild. You get a free written price first.
How long does a running toilet repair take?
Typically under an hour on site once we have the parts.
Can a running toilet raise my water bill?
Yes. A steady leak can add up to a large amount of wasted water over a month. Fixing it is usually far cheaper than the water it wastes.
Should I replace the whole toilet if it keeps running?
Not usually. If the porcelain is sound, replacing tank parts is much cheaper. Replace the toilet if it is cracked, very old and inefficient, or has repeated failures.
Do you repair dual-flush and pressure-assist toilets?
Yes. See our specialty and brand repair page for flush valve and pressure-assist work.

Toilet giving you trouble? Call now for a free estimate.

Same-day scheduling is usually available. You get a written price before any work starts.

Call (888) 784-0722
Call (888) 784-0722 · Free estimates