
Weak or failing flush
A toilet that flushes weakly, half-flushes, or needs two tries is usually not clogged. It often has a worn flush valve, a mis-set chain or button linkage, a scaled-up siphon jet, or, in pressure-assist models, a failing vessel. We diagnose which before quoting.
- Flush valve and seal replacement: the large opening at the base of the tank. Kohler and American Standard use distinct designs, and matching the right one matters.
- Flush button and dual-flush mechanisms: cracked or sticking buttons and misaligned rods, a common failure in modern toilets.
- Handles, chains and linkage: including a broken chain, one of the simplest problems.
- Fill valve and float on premium toilets: Korky and brand-specific parts.
Pressure-assist and Flushmate systems
Pressure-assist toilets use a sealed vessel inside the tank to give a powerful flush, and they are loud when they work and harder to diagnose when they do not. We service Flushmate-style systems, including cartridge, seals and pump-related parts, and we tell you honestly if a replacement toilet makes more sense than an aging vessel.
TOTO, Kohler and American Standard
We work on TOTO toilets and washlet seats, Kohler flush systems, and American Standard flush valves and tank hardware. TOTO's washlet electronics, connections and supply routing are different from a standard seat, so we inspect connection points, water supply, drainage and power before quoting. If a washlet unit itself has failed and needs manufacturer service or replacement, we say so.
Saniflo and macerating toilets
Macerating toilets grind waste and pump it through a small pipe. They are common where gravity drainage is not possible, such as basements, garage conversions and some accessory dwelling units, which are increasingly common in San Diego. We repair and replace macerating units, clear blockages, and address the common causes: wipes, feminine products, and worn seals or switches. If your Saniflo is running constantly, humming without pumping, or backing up, call us.
Typical San Diego pricing
| Repair | Typical range |
|---|---|
| Flush button or handle replacement | $120 to $220 |
| Flush valve and seal replacement | $150 to $300 |
| Pressure-assist cartridge or vessel service | $250 to $450 |
| Washlet install or diagnostic and connection repair | $200 to $450 |
| Macerating toilet repair | $200 to $500 |
Free written estimate first. For basics like flappers and fill valves, see running toilet repair. If a fixture is beyond economic repair, replacement may be the better choice.