
Find where the water is coming from
Dry the toilet and floor completely, then wrap toilet paper around suspect spots and watch which one gets wet first.
- Around the base at the floor: failed wax ring or a damaged flange. Water may appear only when you flush.
- At the tank-to-bowl joint or tank bolts: worn gaskets or corroded bolts, which drip on the bowl or floor.
- At the wall or the small valve: a leaking supply line, shut-off valve packing or compression nut.
- Sweating on the tank surface: condensation, not a leak, though it can look the same.
Base leaks and the wax ring
A wax ring seals the gap between the bottom of the toilet and the drain flange in the floor. When it fails, wastewater seeps out with every flush. A rocking toilet, a floor that feels soft, a musty smell, or a stain on the ceiling below are all warning signs. A leak that runs long enough rots the subfloor.
We remove the toilet, inspect and clean the flange, replace the wax or seal, check that the flange sits at the right height and is not cracked or corroded, and reset the toilet with new hardware. If your bathroom has been retiled, the flange may now sit below the floor, and we fix that with a proper extender so the seal holds.
Bathroom floor repair around the toilet
If the leak has been going on, we check the floor for soft spots and moisture. We tell you plainly what we find, and if flooring or subfloor repair is needed beyond plumbing, we give a separate free estimate so you are never surprised.
Coastal and older homes
Salt air in La Jolla and Pacific Beach corrodes closet bolts and supply hardware faster than inland, and older cast iron flanges in Clairemont tract homes can rust through. Both cause wobbling and slow leaks that go unnoticed.
Typical San Diego pricing
| Leak | Typical range |
|---|---|
| Supply line or shut-off valve replacement | $120 to $250 |
| Tank bolt and gasket replacement | $130 to $260 |
| Wax ring reset with new hardware | $150 to $350 |
| Flange repair or extender, plus reset | $250 to $500 |
Free written estimate first. If a leak is active and you cannot get someone right away, shut off the wall valve and call. Cost details are in our repair cost guide.